← News September 22, 2026

Aximble Ships Its First Force-Control Arm

Diana 7

NOV 5, 2021 · AXIMBLE NEWSROOM

Aximble has shipped its first production unit, bringing torque sensing to every joint on a commercial arm for the first time in the company's short history. The unit left the company's lab after roughly eighteen months of development, most of it spent getting joint-level force sensing to a cost and reliability point where it could ship on production hardware rather than stay a lab prototype.

The arm that shipped is the direct ancestor of what would later become Diana 7 — earlier, lower-payload, and without several of the sensor-fusion features added in later revisions, but running the same core idea: an arm that can feel contact at every joint instead of just at the wrist.

"We started this company because every arm on the market could tell you where it was, but almost none of them could tell you what they were touching. Getting that into every joint, on hardware we could actually manufacture and ship, is the thing we set out to prove."
— Graham Marendino, co-founder and Head of Engineering, Aximble

The shipped unit went to an early pilot customer in electronics assembly, the first of what would become Aximble's core early customer base over the following two years.